Front brakes are still good, rear brake pads about 65% worn.
Oil change was due at 74,300 and vehicle was in at 79,470. Customer stated he had to add oil to vehicle cause it was low. The noise getting from engine was because of low oil. Recommend doing oil change every 3,000 miles. Drain and change oil and oil filter. Check air filter and cabin air filter, good. Check all fluid levels, topped off what was needed. Preform basic safety inspection front and rear suspension. Checked belts and hoses. Set tire pressure to all tires. Check/ clean battery terminals. Reset maintenance light
Scanned computer codes P0442- large EVAP leak and P0456- small EVAP leak. Clear codes at this time, same codes as before. If light comes back on, would need to do smoke test $100 to see problem.
Eric T. gave our service a 5 star review on 5/20/2021
Scanned computer codes P2106, P1295, and P161B. After checking multiple things, come down need to go to dealership, in the computer and needs re-flashed.
Lisa V. gave our service a 5 star review on 4/14/2021
Drain and change oil and oil filter. Check air filter and cabin air filter, good. Check all fluid levels, topped off what was needed. Preform basic safety inspection front and rear suspension. Checked belts and hoses. Set tire pressure to all tires. Check battery connection. Reset maintenance light Next oil change would recommend rear brake pads about $160
Lisa R. gave our service a 5 star review on 2/24/2021
Heard noise right away, pulled wheels and checked rear brakes, pads grinding into the rotors. Remove and replace rear brake pads. Clean, adjust and lubricate all slides. Test drive Front brake pads are still like new.
Right rear door sticks on customer at times, lubricate all slides and hing. Test opens and shuts no problem.
Washer fluid was empty. Oil, coolant, power steering and brake fluid full.
Mike O. gave our service a 5 star review on 2/13/2021
On 1-27-20 and on 6-29-20 and P0153 was on, today light was on dash. Scanned computer code P0153 same code 02 signal slow B2S1. Clear code again, see how long light comes back on. See est attached to fix
Nelson G. gave our service a 5 star review on 2/8/2021
Flanges where the ft and rear exhaust meet is rotted away. Cut out old section and weld in new.
LR Window stuck down. LF window will not go down. Remove panel on LR and check motor. Jump motor and motor does work. Check wiring, found window switch on both non-working windows are bad. Get LR window up, swap switch with RR to RF and now window works by the switch, but not with the master switch. Checking… master switch is bad also. After talking to customer ordered parts for individual windows and gonna leave the master the way it is.
Darlean B. gave our service a 5 star review on 11/18/2020