Mazda Archives - Page 2 of 4 - Anderson Automotive East

2015 Mazda 3
Mileage
98,386
Service Date
4/7/2023
Services Performed
Drain and change oil and oil filter. Check air filter and cabin air filter, good. Check all fluid levels, topped off what was needed. Preform basic safety inspection front and rear suspension. Checked belts and hoses. Set tire pressure to all tires Reset maintenance light
Spark plug maintenance due every 100K- see est attached to fix Everything looks good on vehicle
Riely K. gave our service a 5 star review on 4/7/2023
2009 Mazda 6
Mileage
122,588
Service Date
3/22/2023
Services Performed
Checking battery multi times, coming back bad, recommend new battery. Customer had warranty through Autozone, remove and replace customer supplied battery. Clean / tighten terminals. Alternator charging normal, starter is good.
Compressor is working, is customer having issue with vehicle not getting cold enough, could be just low on freon. Us to look into A/C $44.95 plus freon and dye to system.
Natalie K. gave our service a 5 star review on 3/22/2023
2013 Mazda CX-9
Mileage
332,452
Service Date
2/20/2023
Services Performed
Scanned computer code P0305- misfire on cylinder #5 and P0316. Remove and replace spark plug and coil on #5. Clear codes, test drive
Scanned computer code C1327- brake fluid level low, topped off fluid. Clear light. Brakes check good at this time.
Drain and change oil and oil filter. Check air filter and cabin air filter, good. Check all fluid levels, topped off what was needed. Preform basic safety inspection front and rear suspension. Checked belts and hoses. Set tire pressure to all tires Reset maintenance light
Mike R. gave our service a 5 star review on 2/20/2023
2005 Mazda 6
Mileage
118,340
Service Date
12/22/2022
Services Performed
Drain and change oil and oil filter. Check air filter and cabin air filter, good. Check all fluid levels, topped off what was needed. Preform basic safety inspection front and rear suspension. Checked belts and hoses. Reset maintenance light
Checking fan are running on high 100% of the time. Checking has a bad Control Module. Replace module and retest.
Scanning has 3 lean codes. Check for vacuum leaks… found intake boot bad. Replace boot and retest.
Starter is bad, remove and replace starter. Battery is good. Clean / tighten terminals. Alternator is charging 14.6. With starter removed…. flywheel is chewed up / damaged. Replaced starter, sounds like starter drive is hanging slightly. Should wear in and stop making noise. If after a month still making noise we will replace starter.
Vince C. gave our service a 5 star review on 12/26/2022
2005 Mazda 6
Mileage
116,800
Service Date
10/7/2022
Services Performed
Not seeing anything under car… slight leak on right side. Cleaned service and ran car… just not showing anything. Maybe recheck in a couple weeks …. OR …. may just be getting old and using oil.
Scanned computer codes P2179-system too lean B2 Also had multiple communication codes between computers. UU0073-Control module comm bus A off , U1900-ABS can comm bus fault, and U2516-Can wiring harness open or short. also cleared those and never came back.
Vince C. gave our service a 5 star review on 10/7/2022
2016 Mazda CX-9
Mileage
61,646
Service Date
9/16/2022
Services Performed
Drain and change oil and oil filter. Check air filter and cabin air filter, good. Check all fluid levels, topped off what was needed. Preform basic safety inspection front and rear suspension. Checked belts and hoses. Set tire pressure to all tires Reset maintenance light
When wheels were pulled off, checking the brake wear about 85% worn, check next oil change. When doing brakes would rotate tires.
Sally G. gave our service a 5 star review on 9/17/2022
2005 Mazda 3
Mileage
160,890
Service Date
8/19/2022
Services Performed
Found front left tire loose, remove and checked, everything good. Tighten all lug nuts and set tire pressure to all tires. Test drive
Wanda M. gave our service a 5 star review on 8/20/2022
2016 Mazda CX-5
Mileage
47,370
Service Date
8/8/2022
Services Performed
Maintenance light on, vehicle is about 1 quart low on oil. Drain and change oil and oil filter. Check air filter and cabin air filter, good. Check all fluid levels, topped off what was needed. Preform basic safety inspection front and rear suspension. Checked belts and hoses. Battery is good Brakes are like new Tires are new, set tire pressure to all tires Reset maintenance light
Tom R. gave our service a 5 star review on 8/8/2022
2007 Mazda 3
Mileage
162,286
Service Date
7/11/2022
Services Performed
Drain and change oil and oil filter. Check air filter and cabin air filter, good. Check all fluid levels, topped off what was needed. Preform basic safety inspection front and rear suspension. Checked belts and hoses. Set tire pressure to all tires Reset maintenance light
Checking the compressor is not working correctly, see est attached to fix
Test drove vehicle, felt pulse. Pulled wheels front brake pads 50% worn, rotors are warped. Safe to drive to annoying. See est attached to fix
Gerd C. gave our service a 5 star review on 7/11/2022
2017 Mazda 3
Mileage
69,889
Service Date
6/18/2022
Services Performed
The cruise control button engaging when hitting the clutch
Bryan H. gave our service a 5 star review on 6/19/2022

Mazda

We Service and Repair all Mazda cars